Category Archives: Cisco-Wireless

Add MSE to Cisco prime

This is one simple post, to show how to add MSE (pre-configured) to Cisco prime with three straightforward steps First step: Add the controller to the prime (Create SNMP user/ version then add it)     Second step: Add MSE to … Continue reading

Posted in Cisco-Wireless, WLC Feature | Tagged , , , , | Leave a comment

LAB: WGB with autonomous AP using local RADIUS

In this lab, I am going to connect WGB to autonomous AP that is using local  RADIUS with EAP-FAST. Autonomous AP configurations:  SSID: I am going to use the eap method called nour-method for the dot1x authentication AIR-LAP1141N-A-K9(config)#dot11 ssid WGB … Continue reading

Posted in Autonomous, Cisco-Wireless | Tagged , , , , , , , | Leave a comment

LAB: use WLC internal DHCP to give IP address for access points

Cisco WLC internal DHCP can be used as DHCP for the access points … true! Simple network: WLC <–> switch <–> Access point Switch side: Configure the port as access  with the (management VLAN)  Switch(config)#in FastEthernet0/3 Switch(config-if)#switchport access vlan 5 … Continue reading

Posted in Cisco-Wireless, WLC Feature | Tagged , , | Leave a comment

WiSM 2 in AP-SSO (Pay attention for possible challenges)

I wish to spot the light in two interesting possible challenges after enabling AP-SSO for the WiSM2 First concern:  It is not possible to access the Cisco WiSM2 GUI through the service interface when you have enabled HA. The workaround … Continue reading

Posted in Cisco-Wireless, Wireless-Redundancy | Tagged , , , , , , , , , | Leave a comment

Fail: Controller must be booted with primary image to enable redundancy mode

I was so happy creating AP-SSO lab, I checked that both WLCs are running the same code.  Before I realize that the code is not set to primary in both, I rebooted the primary one and it ended up in … Continue reading

Posted in Cisco-Wireless, Wireless-Redundancy | Tagged , , | 1 Comment

LAB: Configure two WiSM2 for HA AP-SSO

In this lab I want to show the steps to configure two standalone WiSM2 to be AP-SSO redundancy! Preparing for the LAB: Each WLC has management IP and the initial configurations are done Each WiSM has service port (which is … Continue reading

Posted in Cisco-Wireless, Wireless-Redundancy | Tagged , , , , | Leave a comment

Redundancy Management Interface Vs Redundancy Port (AP-SSO)

Redundancy Management Interface The active and standby-hot controllers use the Redundancy Management Interface to check the health of the peer controller and the default gateway of the management interface through the network infrastructure. The Redundancy Management Interface is also used … Continue reading

Posted in Cisco-Wireless, Wireless-Redundancy | Leave a comment